Story

Challenge:  Create a one of a kind entrance for a one of a kind dealership, with some guidelines of course.

Matching an aluminum design on other dealerships, we fabricated panels from 14 gauge, type 304 stainless steel with a No. 4 finish.  Frame is a welded construction, pre-drilled and tapped to accept hidden fasteners.

Panels were fabricated in sections to allow for replacement if damaged.  Access panel installed in the back of enclosure to allow for removal of face panel if needed.  There are studs on the inside, but the panel face shows no fasteners creating a clean, 21^st-century look.

Challenge met?  We think so.